Keyless Entry System; Program Remote Keyless Entry; Transmitter - DaimlerChrysler LH New Yorker 1994 Electronic Service Manual

(4) Insure that solenoid plunger travel is adequate
approximately 16 mm (5/8 inch).
ADJUSTMENT
Adjust deck lid latch and striker so that deck lid
latches with a moderate slam. With ignition switch
in On or Accessory position, push deck lid unlock
switch. Should latch fail to lock or unlock replace
latch assembly.
DECK LID SOLENOID REMOVAL
(1) Raise trunk lid to the full up position.
(2) Remove latch cover attaching screws then re-
move cover.
(3) Remove two mounting solenoid screws and re-
mote key cable retainers then remove solenoid.
(4) For installation reverse above procedures.

KEYLESS ENTRY SYSTEM

The system allows locking and unlocking of vehicle
door(s) and trunk lid by remote control using a hand
held radio frequency transmitter. The ignition switch
must be OFF before the trunk lid can be unlocked
with the transmitter.
The receiver may receive signals from two trans-
mitters. Each transmitter has its own code, and the
code is programmed and stored into receiver
memory. If the transmitter is replaced or a second
transmitter is added, the codes of both units have to
be reprogrammed into the receiver memory. If a
receiver module is replaced, the transmitter codes
must be stored in the new receiver memory.
OPERATION
The transmitter has three buttons for operation
(Fig. 3). They are LOCK, UNLOCK and TRUNK re-
lease.
Fig. 3 Transmitter
• The UNLOCK button will unlock the driver's door
and enable illuminated entry. Pushing and releasing
the button once will unlock the driver's door. Pushing
and releasing the button two times, within five sec-
onds interval, will unlock all doors.
• Upon pressing the LOCK button, the horn will
sound a short CHIRP to notify that the all door lock
signal was received and set.
• The TRUNK UNLOCK button will slightly ajar the
trunk lid.
The receiver is capable of retaining Vehicle Access
Code (VAC) even when power is removed.
Each remote keyless entry module (RKE) must
have at least one and no more than two transmitters.
TRANSMITTER CONTROL RANGE
Operation range is within 9 meters (30 ft.) of the
receiver.
TRANSMITTER BATTERY
The transmitter has two 3 volt batteries, which can
be removed and replaced without special tools. The
battery is available at local retail stores. Recom-
mended battery is Duracell DL 2016 or equivalent.
Battery life is about one to two years (Fig. 3).

PROGRAM REMOTE KEYLESS ENTRY

TRANSMITTER

(1) Remove the middle vent bezel from the instru-
ment panel.
(2) Locate the 2x3 traction control black connector
(Fig. 4). The connector will either be connected to the
switch or the back of the bezel housing. Disconnect
the connector.
Fig. 4 Middle Vent Bezel
(3) Turn ignition switch to the ON position.
(4) Ground pin 4 of the traction control connector
(Fig. 5). This is the programming line for the Remote
Keyless Entry Module. The door locks will lock and
unlock, to indicate the receiver is ready to receive
transmitter code. The trunk solenoid will not cycle at
this time.
(5) Press any button on the transmitter to set code.
The locks will cycle to confirm programming. If there
is a second transmitter it must be set at this time.
Press any button on the second transmitter and wait
for the locks to cycle.
POWER LOCKS 8P - 3