Steering Shaft; Removal And Installation - Mitsubishi MOTORS Lancer 2004 Workshop Manual

REMOVAL AND INSTALLATION

WARNING
Before removing the steering wheel and air bag module assembly, refer to GROUP 52B,
Service Precautions (P.52B-5) and Air Bag Module and Clock Spring (P.52B-210).
Pre-removal Operation
• Steering Wheel and Air bag Module Assembly Removal
(Comfort: refer to P.37-17/Sport: refer to P.37-19).
• Under Cover Removal (Refer to GROUP 52A, Instrument
Panel P.52A-2).
Section A - A
2
Tab
1
B B
B
B
Specified sealant:
3M ATD Part No.8513 or equivalent
Removal steps
1. Lower column cover
2. Upper column cover
3. Clock spring and column switch
assembly
4. Cover <A/T>
REMOVAL SERVICE POINT
<<A>> STEERING COLUMN SHAFT
ASSEMBLY REMOVAL
CAUTION
The tilt lever should be held in the lock position
until the steering column shaft is installed to the
vehicle. If the steering column is removed with
the tilt lever released, or the tilt lever is released
after the steering column shaft was removed
POWER STEERING

STEERING SHAFT

STEERING SHAFT
M1372011500113
Section B - B
Toe board
8
8
Post-installation Operation
• Under Cover Installation (Refer to GROUP 52A,
Instrument Panel P.52A-2).
• Steering Wheel and Air bag Module Assembly Installation
(Comfort: refer to P.37-17/Sport: refer to P.37-19).
2
7
12 ± 2 N·m
6
18 ± 2 N·m
5.0 ± 1.0 N·m
Removal steps (Continued)
5. Key interlock cable <A/T> (Refer to
GROUP 23A, A/T Key Interlock and
Shift Lock Mechanism P.23A-151).
6. Shaft cover
<<A>> >>A<<
7. Steering column shaft assembly
8. Cover assembly
from the vehicle, the steering column can not be
reinstalled correctly. If the steering column is
installed incorrectly, the collision energy
absorbing mechanism may be damaged.
1. Ensure that the tilt lever is in the lock position, and
remove the steering column mounting bolts.
2.5 ± 0.5 N·m
(mounting screw)
A
A
1
4
5
AC304919 AB
37-21
3