Chevrolet Corvette 1963 Repair & Tune-Up Manual page 237

20-32 N-m
(15-23 FT. IBS.)
ROD-REVERSE
27-40 N-m
(20-30 FT. IBS.)
Linkage adjustments—1984 4-speed overdrive transmission
levers. Hand tighten the forward and rear ad-
justing nuts at the same time with equal force.
Do this for all three shifter rods and then
torque the forward and rear adjusting nuts at
the same time to specifications.
FINGER GRIP
BOOT ASM
ASM ONTO LEVER AND BRACKET
2. INSTALL SPRING INTO HOLE
OF LEVER AND BRACKET ASM.
3. ASSEMBLE KNOB BY TURNING CLOCKWISE ONTO
THREADS OF LEVER AND BRACKET ASM UNTIL FIRMLY
SEATED IN PLACE. SLOT OF KNOB MUST BE IN LINE
WITH SLOT Of LEVER AND BRACKET ASM.
4. ALIGN AND FIRMLY SEAT PIN INTO "T" SLOT OF KNOB
AND SLOT OF LEVER AND BRACKET ASM.
6. ALIGN AND ASSEMBLE BUTTON INTO GROOVE OF KNOB
THEN FIRMLY SEAT BUTTON IN PLACE AS SHOWN.
Shifter knob removal—1984 and later
CLUTCH AND TRANSMISSION
ROD-3RD & 4TH
ROD-3RD & 4TH
ROD-1ST&2ND
BUTTON
PIN
BUTTON
KNOB ASSEMBLED
1. INSTALL FINGER GRIP
ASM, ALIGNING TANG OF
FINGER GRIP INTO SLOT OF
LEVER AND BRACKET ASM
SEATING FINGER GRIP ASM
TO SHOULDER ON LEVER
AND BRACKET ASM.
GAGE PIN
11. Reinstall the components removed by
reversing Steps 1 through 7. Lubricate all
linkage pivot points.
NOTE: //, after adjusting the linkage, it is
found that high shift effort still exists, an
anti-chatter
(positraction additive) may
be used. The lubricant is
available in a small
plastic bottle and can be
squirted
transmission
the filler plug.
Oil Pan and Filter
REMOVAL AND INSTALLATION
4 Speed Overdrive Only
1. Raise the vehicle and support it safely.
2. With drain pan placed under overdrive
POSITION MAGNET IN
Place magnet as shown when Installing oil pan on
overdrive unit—1984 and later
219
lubricant
into the
through
R.T.V. SEALANT
CORNER