Stitch W I D T H K N O B; Reverse Sewing B U T T O N - Brother VX880 How To Use And Enjoy Manual

S T I T C H W I D T H K N O B
I
N E E D L E POSITION SELECTOR
I
a l l
- -
L M R
m m m
The zlgzag w ~ d t h
IS
regulated by operating
the stitch width knob.
Numerals above the knob represent the
width of stitch. T H E HIGHER T H E
NUMBER, THE WIDER T H E STITCH.
The "0" means straight stitch only.
NOTE: 1. Do not move the knob while
the needle is in the material.
2.
When using t w i n needle, knob
should always be set at under
"3".
By shifting this lever t o L (left), M (middle)
or R (right), you will be able t o sew straight
and zigzag stitches as the base line.
When you sew close t o the edge of material,
select L or R so that you can obtain better
feeding of the material.
For almost all stitching, this selector t o
be set at M (middle) but set other position
for following application.
1. Button sewing (page 29)
2. Decorative stitches (page 21 )
NOTE: 1. Do not move the selector while
needle is in the material.
2. Set the selector always at M
when you use t w i n needle.
REVERSE SEWING B U T T O N
T o sew in reverse, push sewing button
as far as it will allow. Hold button in this
position until you wish t o sew forward.
When button is released i t will spring back
in position and you will sew in forward
direction.
Reverse sewing is used for back-tacking and
reinforcement.