Connecting Plugs; Controlling Sewing Speed - Brother VX880 How To Use And Enjoy Manual

I
Operating Your Sewing Machine
CONNECTING PLUGS
1. First connect the three-prong plug into
the machine.
2. Then connect the electric supply plug
into a wall outlet.
Caution
When changing needle, bobbin or
light bulb, or when sewing machine is
not in use, it is recommended that
electrical supply plug is disconnected
t o avoid electrical hazards.
Remark:
The illustration on this page depict-
ing the use of t w o pin plug is not
applicable t o use in U.K.
CONTROLLING SEWING SPEED
Place foot on foot control as shown in
illustration.
When foot control is pushed down lightly,
machine will run at a l o w speed.
When pressure on f o o t control is increased,
machine will pick up speed.
When foot control is released, machine will
stop.
NOTE:
1. Care should be taken that nothing is placed on f o o t controller when machine is not in use.
2. A n e y sewing machine or one that has n o t been in use for a long period of time should
be oiled as per instruct~on o n page 35 & 36. After oiling, be sure t o wiper up any excess oil.