Installation And Use - All Pond Solutions 1400EF Instruction Manual

ELECTRIC
This unit comes complete with a generous supply of 3 core cable, however
should any additional cable be required, the use of an approved waterproof
cable connector with a proper rating is essential. A cord rated for less amperes
or watts than the appliance rating may overheat.
Please Ensure:
The power supply must be earthed and fused at 3amps.
·
You regularly inspect the cable for damage and deterioration.
·
Do not connect to any voltage other than that stated.
·
You consult a qualified electrician if in doubt about any aspects of
·
wiring.
The external filter comes complete with a generous supply of 3 core cable,
however, should any additional cable be required then the use of an approved
waterproof cable connector is essential. A cord rated for less amperes or watts
than the unit may overhead.
Please Ensure: The power supply must be earthed and fused at 3amps.
Regularly inspect the cable for damage and deterioration. Consult a qualified
electrician if in doubt about any aspects of wiring.
INSTALLATION & USE
Please read the below instructions carefully before beginning to set up your
filter. DO NOT CONNECT THE UNIT TO THE MAINS UNTIL SET UP IS
COMPLETE AND UNIT IS FILLED WITH WATER.
Important installation information:
The base of the unit must NOT be more than 1.4m (4.5 ft) below the tank
·
water level.
The water level must NOT be more than 17cm (7 inches) below the tank rim.
·
It is essential to position your external filter BELOW your aquarium.
·
The green hose must be kept taut with no loops and follow a STRAIGHT
·
LINE from the filter to the rim of the aquarium. If the hosing is too long the
filter WILL NOT WORK CORRECTLY.
The inlet pipe should NOT be positioned too close to an air stone, aeration
·
device or the output valve to avoid reducing the effectiveness of the filter.