9.4 What to do if...
The oven display is completely off
The oven does not heat up
The controls do not respond.
The cooking times are longer
than those indicated in the table.
After the automatic cleaning
cycle it is not possible to select
a function.
The display shows ERR 4
The fans stop when the door is
opened during a convection
function.
30
Instructions for the user
•
Check the mains power supply.
•
Check whether an omnipolar switch upstream from the oven feed
line is in the "ON" position.
•
Check whether the "showroom" mode has been set, for further
details see paragraph "Secondary menu" on page 17.
•
Check whether the "child lock-out function" mode has been set,
for further details see paragraph "Secondary menu" on page 17.
•
Check whether the "PO" mode has been set, for further details
see paragraph "Secondary menu" on page 17.
•
Verify whether the door interlock device has turned off. If it has
not, the oven has a protection device that does not allow
functions to be selected while the door interlock device is active.
This is because the temperatures inside the oven are still too
high to allow any type of cooking.
•
The door interlock device has not hooked to the door properly.
This might be because the door was accidentally opened during
its activation. Turn off the oven and turn it on again waiting a few
minutes before selecting a new cleaning cycle.
•
This is not a fault. It is a normal operation of the appliance,
useful when cooking foods in order to avoid excessive heat from
escaping. When the door is closed, the oven will return to normal
operation.