Table of Contents
Advertisement
Instructions for the user
5.6.2 Automatic cooking
Automatic cooking is the function which allows a cooking operation to be started at a set time and then
ended after a specific length of time that is set by the user.
Select a cooking function, set the desired cooking temperature or leave the preset temperature (see
paragraph "5.5 Selecting a function") and press PT1 twice. The display will show the
figures and
the
symbol (flashing).
Turn PT1 to the right or left to set the cooking time (from 00:01 to 23:59).
For safety reasons, when setting automatic cooking the user must first program a cooking duration and
then set the cooking start time. It is not possible to set just the cooking start time, without setting the
cooking duration.
After setting the duration, press PT1 once.
The
symbol and the current time will appear on the display.
Turning PT1 to the right increases the time, allowing the desired cooking start time to be set.
A few seconds after the desired duration is set, the
and
symbols will stop flashing, and the oven
will start to wait for the starting time setting. At the end, the word STOP will appear on DSP1, cooking will
stop and a buzzer will sound; press PT1 once to deactivate it.
If you wish to continue cooking beyond the set time, press PT1 again. The oven will restart normal
operation with the temperature settings selected previously.
PT2 has to be pressed to turn the oven off completely.
Modifying the setting
Once automatic cooking has started, its duration can be changed.
When the
and
symbols are steady on and cooking is in progress, or the oven is in stand-by
status waiting for cooking to start, press PT1 once. The
symbol starts flashing and PT1 can be
turned to change the set duration.
Press PT1 again; the
symbol turns off, the
symbol will start to flash, and the cooking start time
will be displayed on DSP1. The cooking start time can be increased or decreased by turning PT1.
A few seconds after the last change, the
and
symbols will appear (in steady on mode) on DSP1
and automatic cooking will restart with the new settings.
Once cooking has been programmed, before it starts, the function symbol will remain on, as will the
symbols
,
.
16
Advertisement
Table of Contents
