Transmitter Input Modes; Receiver Output Modes; Mixed Modes; Navigating The Lcd - Lectronics D4 Instruction Manual

Transmitter Input Modes

The transmitter can be set up in three different con-
figurations with the AES3 mode menu for 4-channel
operation:
DIGITAL
ANALOG CH 1
DIGITAL
ANALOG CH 2 NOT USED
CH 3
ANALOG ANALOG
CH 4
ANALOG ANALOG
Two different configurations are available for 2-channel
operation:
DIGITAL
ANALOG CH 1
DIGITAL
CH 2
ANALOG NOT USED
NOT USED NOT USED
CH 3
NOT USED NOT USED
CH 4

Receiver Output Modes

The receiver audio outputs can be configured in the
same manner as the transmitter for 4-channel opera-
tion:
CH 1 CH 1
ANALOG
CH 2 ANALOG CH 2
CH 3 ANALOG CH 3
CH 4 ANALOG CH 4
Two different configurations are available for 2-channel
operation:
DIGITAL
CH 1 CH 1
DIGITAL
CH 2 NOT USED CH 2
CH 3 NOT USED CH 3
CH 4 NOT USED CH 4
Rio Rancho, NM, USA
DIGITAL
CH 1 CH 1
DIGITAL
DIGITAL
CH 2 CH 2
DIGITAL
NOT USED
CH 3 CH 3
NOT USED
CH 4 CH 4
CH 1
CH 2
CH 3
CH 4
DIGITAL DIGITAL
CH 1
DIGITAL DIGITAL
DIGITAL
CH 2
NOT USED
DIGITAL
NOT USED
ANALOG CH 3
NOT USED
ANALOG CH 4
ANALOG
ANALOG
NOT USED
NOT USED
4-channel Digital Wireless System

Mixed Modes

The selected AES3 modes on the transmitter and re-
ceiver do not have to be identical. For example, analog
signals can be fed into the transmitter from a mixer or
wireless mic receivers, transmitted to the D4 receiver,
which can be configured for four digital outputs to feed
a digital recorder.
The sampling rate of the audio at the receiver digital
outputs will always be at 48 kHz, regardless of the
sampling rate of the signal fed into the transmitter.
NOTE: Transmitter and receiver must both be set
to either the 2-channel or 4-channel mode.

Navigating the LCD

Navigation through setup screens is the same on
transmitter and receiver. The Main Window will display
audio levels for all active channels while the system is
operating. Press the FUNC button to enter the setup
menu.
DIGITAL 4 CHANNEL TRANSMITTER
FUNC
BACK
1 2
Then press the UP and DOWN arrow buttons to select
a menu item.
DIGITAL 4 CHANNEL TRANSMITTER
FUNC
BACK
1 2
Press the FUNC button to enter the setup screen for
the selected item. Then use the UP and DOWN arrow
buttons to select a value or mode.
DIGITAL 4 CHANNEL TRANSMITTER
FUNC
BACK
1
2
Press BACK once to return to the Menu or twice to
return to the Main Wiindow.
3 4
OFF ON
3 4
OFF ON
3 4
OFF ON
7