BD 172668 Operating Instructions Manual page 13

BD DROP SAW
CUTTING HEAD ADJUSTMENTS
Two bolts are located under motor mount
plate to adjust stop plate for cutting head
stop height.
BD DROP SAW SETUP FOR OPERATION
1. Check for damaged, broken, or missing parts.
CAUTION
2. Verify the On/Off switch is in the OFF position.
3. Before connecting the MK-660 Saw to a power supply, be sure the voltage, cycle
4. If using an extension power cord, make sure the length and wire gauge
5. Use an approved Ground Fault Circuit Interrupter (GFCI).
6. Do not cover the motor vents as this could lead to motor overheating.
NOTE: In order to avoid breaker tripping, a 20-amp circuit breaker should be used.
NOTE: Barranca Diamond has available, as an accessory item, (Part # 152610) a plug-in GFCI
that may be plugged into a properly installed and grounded 3-pole outlet.
(A)
and phase of the job site power source meet the requirements of the table below:
VOLTAGE:
CYCLE:
PHASE:
correspond to the requirements listed in the table on page 8. An extension
power cord that is too small in wire gauge (diameter), or too long in length, will
cause the motor to overheat and could cause premature failure.
(A) Ensure the ON/OFF Switch is in the OFF position
(B) Plug BD Drop Saw into the GFCI
(C) Plug the GFCI into the power source
Pivot adjustment bolts are located on
either side of cutting head vertical support
for adjustments or motor removal.
120v
60hz
1-phase
13
ASSEMBLY
(B)