Assembly - BD 172668 Operating Instructions Manual

BD DROP SAW
WATER PUMP INSTALLATION
(A)
Press one end of the water
tube onto the water pump
discharge fitting.
(D)
Fill water tank with clean
water until water pump is
covered with 1-2" of water.
(G)
Connect the water pump
power cord to the connection
found on the motor.
NOTICE:
Be sure to check the water level inside the reservoir frequently to ensure water pump is covered
with water at all times.
(B)
Remove cutting table
and place water pump in
water tank.
(E)
Install cutting table.
(H)
There are two set screws on
the front of the water tank
that secure the cutting table
to the water tank.
11

ASSEMBLY

(C)
Ensure drain plug is tightly
fitted.
(F)
Ensure pump cord and water
tube exit through the slot in
the rear of the cutting table.
(I)
There are two set screws on
either side of the water tank that
can be used for cutting table
alignment or securing the cutting
table to the water tank if needed.