Page 3
1103909902 DW9230 D1_110x220mm 22/04/13 12:16 Page3 HIGH PRECISION TIP EN......5 ES ......35 FI......65 FR ......11 PT ......41 DA ......71 DE......17 EL ......47 AR......82 NL......23 SV......53 IT ......29 NO ......59...
1103909902 DW9230 D1_110x220mm 22/04/13 12:16 Page5 SAFETY INSTRUCTIONS • Please read these instructions carefully and keep them for further references. • Never leave the appliance unattended when it is connected to a power source; if it has not cooled down for approximately 1 hour.
Page 8
1103909902 DW9230 D1_110x220mm 22/04/13 12:16 Page6 IMPORTANT RECOMMANDATIONS • The voltage of your electrical installation must correspond to that of the iron (220-240V). Always plug your iron into an earth socket. Connecting to the wrong voltage may cause irreversible damage to the iron and will invalidate the guarantee.
1103909902 DW9230 D1_110x220mm 22/04/13 12:16 Page7 DESCRIPTION Auto off Self clean button Shot of steam button Spray Steam ON / Steam OFF High precision tip Cord Soleplate Handle Filling inlet Spray trigger Temperature control dial Thermostat control light Rear Cover Water tank STEAMFORCE, CONCENTRATED INNOVATION…...
1103909902 DW9230 D1_110x220mm 22/04/13 12:16 Page8 THERMOSTAT IRONING FABRIC THERMOSTAT INDICATION LABEL Nylon (Synthetic fibres, e.g. viscose, NYLON polyester) silk SILK wool WOOL cotton COTTON linen LINEN IMPORTANT The iron takes longer to cool down than to heat up. We recommend that you start with fabrics to be ironed at a low temperature.
When the appliance has cooled down, wipe the iron down with a damp cloth or sponge. A non abrasive cleaning agent can be used. Alternatively the ROWENTA cleaning kit ZD100 D1 can be used. After cleaning the soleplate, use the Self Clean function to remove residues of the cleaner from the steam holes.
Page 12
1103909902 DW9230 D1_110x220mm 22/04/13 12:16 Page10 PROBLEMS Problem Cause Solution The iron is plugged in, but No mains supply. Check that the mains plug is the soleplate of the iron properly inserted or try remains cold. plugging the iron into a different socket.
Need help?
Do you have a question about the DW9230 and is the answer not in the manual?
Questions and answers