Tools Required - Dometic Cabana Lightweight RV Dome Awning Installation And Operation Instructions Manual

CONTENTS:
Bag Awning/Room
(1) Flex Pole (collapsible)
(16) Snap Fast Fasteners
(3) Roof Poles (adjustable)
(25) Tent Stakes
(2) Hold Down Webbing Straps
Mesh Vehicle Skirt
Mesh Wheel Well Skirt
Flex Poles
Tent Stakes

TOOLS REQUIRED:

Power Drill/Screwdriver
Silicone spray/Lubricant
A. Slide Bag Into Standard Awning Rail
1. Spray inside of awning rail with silicone spray
or lubricant to ease sliding bag through
awning rail. Make sure Dometic logo faces away
from camper.
2. If the awning is to be left mounted during travel,
secure each end by installing a #6 X 1/2" (includ-
ed) drill point screw in each end.
Awning Rail
6 X 1 / 2 "
Screw
Roof Poles
Snap Fast Fasteners
Edge Of
Awning Rail
Cabana Lightweight RV Dome Awning™ Installation and Operation Instructions
3. Unzip bag & undo ties to roll fabric assembly out.
Unrolled fabric assembly
B. Assemble Poles and Dome Awning: Flex
Collapsible Pole (1) & Telescoping Alu-
minum Poles (3)
1. Assemble collapsible flex pole. Prepare Dome
Awning for flex pole by unzipping front panel from
the bottom up. Stop approximately at the buck-
les. Insert flex pole into sewn-in pocket located
on front of Dome Awning. Push flex pole through
entire front pocket.
Note: Do not try to pull flex pole through. Pulling will only
disassemble sections of the flex pole.
3