Advertisement
If the device already belongs to a network, follow the exclusion process before
including it in your network. Otherwise inclusion of this device will fail. If the
controller being included was a primary controller, it has to be reset first.
To confirm Inclusion or Exclusion hit the button on the device.
Operating the device
The device is able to dim electric load up to 300 W. Short press of the button will
toggle. This means that the power will be turned on if it was off and turned off when it
was on. When switching the lamp on or off the light will dim for about 2 seconds until
the final level is reached.
The the button is constantly pressed the light will be dimmed. The dimming function
will also toggle. Constantly pressing the the button will either dim up or dim down the
light until it reaches the final level.
Configuration Parameters
Z-Wave products are supposed to work out of the box after inclusion, however certain
configuration can adapt the function better to user needs or unlock further enhanced
features.
IMPORTANT: Controllers may only allow to configure signed values. In order to set
values in the range 128 ... 255 the value sent in the application shall be the desired
value minus 256. For example: to set a parameter to 200 it may be needed to set a value
of 200 minus 256 = minus 56. In case of two byte value the same logic applies: Values
greater than 32768 may needed to be given as negative values too.
LED- Behavior (Parameter Number 1, Parameter Size 1) defines the behavior of the
blue LED
Value
Description
0
blue indicates off (Default)
1
blue indicates on
Technical Data
Power Supply
230V ~50-60 Hz
Advertisement
