TKB Home TZ67-F Manual

TKB_TZ67-F
Z-Wave Wall Plug Dimmer for Typ F
Firmware Version : 1.4
Quick Start
A This is a Z-Wave actuator. Inclusion and Exklusion are confirmed by hitting the
button one time.
Please refer to the chapters below for detailed information about all aspects of the
products usage.
Product description
The TKB TZ67 is a dimmer plug that can be placed between a wall outlet for Typ F
Plug and electric devices, plugged in by cord. It can dim resistive loads up to 300 W.
The device is IP 20 rated and can therefore only be used in dry environments. For
dimming the devices apply leading edge phase cutting. It is therefore only possible to
dim incandescent lamps and high voltage halogen lights. Low voltage halogen lights,
LEDs and CFLs must not be attached. Dimming is controlled wirelessly using Z-Wave
or locally applying a button. A blue LED indicates the dimming status.
Installation Guidelines
The Dimmer Plug can be plugged into every wall outlet for Plug-Type F (France,
Poland, ...). It is IP20 rated and can therefore only be used in dry environments. Do not
locate the device facing direct sunlight, humid or dusty place. The suitable ambient
temperature for the device is 0°C ~ 40°C.
Behavior within the Z-Wave network
I On factory default the device does not belong to any Z-Wave network. The device
needs to join an existing wireless network to communicate with the devices of this
network. This process is called Inclusion. Devices can also leave a network. This
process is called Exclusion. Both processes are initiated by the primary controller of the
Z-Wave network. This controller will be turned into exclusion respective inclusion
mode. Please refer to your primary controllers manual on how to turn your controller
into inclusion or exclusion mode. Only if the primary controller is in inclusion or
exclusion mode, this device can join or leave the network. Leaving the network - i.e.
being excluded - sets the device back to factory default.