Assembly - Ariens Sno-Thro 938017 Owner's/Operator's Manual

ALWAYS keep protective structures, guards,
and panels in good repair, in place and
securely fastened. NEVER modify or remove
safety devices.
DO NOT change engine governor settings or
over-speed engine.
Fumes from engine exhaust can cause injury
or death. DO NOT run engine in an enclosed
area. Always provide good ventilation.
ALWAYS maintain unit in safe operating
condition. Damaged or worn out muffler can
cause fire or explosion.
Keep all hardware properly tightened.
Maintain or replace safety and instruction
labels, as necessary.
NEVER store unit with fuel in fuel tank, inside
a building where any ignition sources are
present.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
TOOLS REQUIRED
7/16" Open-end wrench

ASSEMBLY

Handlebar Assembly
1. Remove retaining nuts and handlebar
knobs and release J-bolts from lower
handlebar (figure 3).
2. Unfold upper handlebar.
NOTE: Adjust handlebar to a height
comfortable for the operator (see Handlebar
Height Adjustment on page 13).
3. Put J-bolts through the upper handlebar
and lower handlebar holes.
4. Replace retaining nuts and tighten
handlebar knobs to secure upper
handlebar.
Shut off fuel and allow engine to cool
completely before storing in closed area or
covering unit.
For extended storage, clean unit thoroughly.
See Engine Manual for proper storage.
Use only attachments or accessories
designed for your unit.
Check components frequently. If worn or
damaged, replace with manufacturer's
recommended parts.
ASSEMBLY
2
1
1. Lower Handle
Bar
2. Upper Handle
Bar
Discharge Chute Assembly
1. Remove bolt and nut from rear of
discharge chute (figure 4).
2. Tip discharge chute up and install
hardware just removed. Tighten
hardware at rear of discharge chute first,
then sides.
GB - 9
3
6
Figure 3
4
5
3. Auger Clutch
Bail
4. Knob
5. J-Bolt
6. J-Bolt Holes
DS0072