Advertisement

Quick Links

M13 Device description
Version 0.1 – APR 7th 2009

Advertisement

Table of Contents
loading

Summary of Contents for LG M13

  • Page 1 M13 Device description Version 0.1 – APR 7th 2009...
  • Page 2 Part 15.21 statement " Change or Modifications that are not expressly approved by the manufacturer could void the user's authority to operate the equipment. “ Part 15.105 statement This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules.
  • Page 3 Part 15 Class B Compliance This device and its accessories comply with part15 of FCC rules. Operation is subject to the following two conditions: (1) This device & its accessories may not cause harmful interference. (2) This device & its accessories must accept any interference received, including interference that may cause undesired operation.
  • Page 4 Copyright © 2009 LG Electronics Inc. All Rights Reserved. Though every care has been taken to ensure the accuracy of this document, LG Electronics Inc. cannot accept responsibility for any errors or omissions or for any loss occurred to any person, whether legal or natural, from acting, or refraining from action, as a result of the information contained herein.
  • Page 5 1.1. Feature Caution To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm (8 inches) between the equipment and the body must be maintained. <UE> <User> At least 20 cm (8 inches)
  • Page 6: About This Document

    1.1. Feature About This Document Revision History Version Date Comment Author 2009-04-07 Initial Draft Sang Ha Park References...
  • Page 7: General Description

    1.1. Feature General Description...
  • Page 8 This document describes briefly the board level operations, key features and the environment of the M13 Platform. The purpose of this platform is the verification of LG LTE ASIC, namely ‘L1000’, and the evaluation of LG UE system performance. The further details about the characteristics and functions of L1000 are available on other documents.
  • Page 9 1.1. Feature Modulation Method Up to 16QAM Receiver Rx Diversity Support Adaptive MIMO 2x2 MIMO switching between downlink Transmit Diversity and SU MIMO Band width 10MHz Modulation Method Up to 64QAM Interface Interface protocol USB Ethernet CDMA USB Driver 3 Ports (Data, DM, Control) CDMA 3 Ports (Data, DM, Control) Downloading tool...
  • Page 10 1.1 Feature CDMA IP Mobility Proxy mobile IPv4/6 eHRPD Support CDMA Non optimized IRAT handoff Active handoff handover Non optimized Idle handoff handover IRAT measurement Mechani Mechanical Dimensions (W xD xH) 185 x 133.9 x 22.8 mm Weight 420g Antenna Internal Antenna (MIMO)
  • Page 11: Mechanical Description

    Mechanical description...
  • Page 12 2.1 Front / Rear / Side View Front / Rear / Side View <Fig 4-1. M13 Mechanical Part Top View> <Fig 4-2. M13 Mechanical Part Bottom View> <Fig 4-3. M13 Mechanical Part Side 1 View>...
  • Page 13 2.1. Front / Rear / Side View <Fig 4-4. M13 Mechanical Part Side 2 View>...
  • Page 14 2.2 Dimension Dimension M13 Mechanical dimension is 133.9 x 185 x 22.8mm.
  • Page 15: Functional Description

    2.2. Dimension Functional description...
  • Page 16 3.1 Functional Key description Functional Key description LTE trial device picture is below. <Fig 5.1 LTE & eHRPD LTE Trial Product Picture> This product has some key to operate LTE trial device. Send key : This key is used to call. Clear key : This key is used to erase character or number.
  • Page 17 3.2. External connector description External connector description Our LTE Trail device has several external connectors. DC input jack connector: External Power source, 5V TA USB connector: USB Connect to Host (PC) SIM socket: for LTE Authentification 24Pin connector: For debug LTE Sub board HW Reset key DC input Jack USB cap...
  • Page 18 3.3 External RF connector description External RF connector description LTE MIMO ANT mobile SW LTE Main ANT mobile SW CDMA ANT Mobile SW GPS ANT mobile SW LTE Trial device has 4 external RF connectors in order to measure wired RF performance characteristic.
  • Page 19 3.4. Antenna description (LTE & CDMA) Antenna description (LTE & CDMA) 3.4.1 CDMA Antenna description M13 Device LTE Antenna: Dual band, Single Feeding Antenna Type: Carrier & PIFA Directive: Omni-directiona Ant. : 1TX and 1RX CDMA 3D Gain: TX:--5.9dB, RX: -3.7dB USPCS 3D Gain: TX: -6.1dB, RX: -5.1dB...
  • Page 20 3.5 External Power description External Power description To operate and charge the battery, plug the AC Adapter into a standard wall outlet and connect it to the LTE trial device via the DC input jack Connector. External power supply is DC input jack or TA. This power supply specification is below.
  • Page 21: Battery Description

    3.6 Battery description Battery description Our LTE Trial device has a two Battery. One is used for operating CDMA modem part, and another is used for operating LTE modem part. Battery Capacity for used in CDMA part is 1100mAh. But in order to operating fully LTE performance, it is need to larger battery capacity. And then we selected 2400mAh cylindrical battery.

Table of Contents