Installing The Memory Card; Connecting Your Device To A Computer - Mio MioCARE+ A105 Series User Manual

en

Installing the memory card

1. Open the cover on the left side of the device to locate the memory card slot.
2. Hold the microSD card by the edges and gently insert it into the slot with the
label facing the back of your device.
CAUTION! Do not apply pressure to the centre of the memory card.
3. To remove a card, gently push the top edge of the card inwards to release it,
and pull it out of the slot.
IMPORTANT! Before removing the memory card, you are recommended to
unmount it from the system. To unmount the memory card, tap Storage >
Unmount SD card from the Settings menu.

Connecting your device to a computer

Connect the Micro-USB end of the USB cable to your
device and the other end to a USB port in your computer.
Tip: If this is the first time you connect the device to your
computer, you need to install the USB driver on your
computer when prompted. The device's USB driver is
available from Mio's website: http://miocare.mio.com/
CAUTION!
The IEC 60529/IP54 is a European system of test specification standards for classifying the degree
of protection provided by the enclosures of electrical equipment. An IP54 designation means that
the unit withstands dust protected (Ingress of dust is not entirely prevented, but it must not enter
in sufficient quantity to interfere with the satisfactory operation of the equipment; complete
protection against contact), and water splashing for up to 5 minutes (water volume: 10 litres per
minute, Pressure: 80-100kPa). Mio guarantees this grade provided the battery door and all jack
covers are properly and securely closed. This device is not IPX7/IPX8 grade; immersion in water
or water-pressure such as washing the unit with running water may cause damage to the unit and
voids warranty.
4