Mixer Operation; Monitor Source Selection - Sony MXP-310 Manual

3-2 Mixer Operation

3-2-1 Monitor Source Selection

SEND monitoring
Pre-fader listening (PFL) monitor
The signals routed to the MONI OUT connectors are selected with the
switches of the MONITOR SOURCE section.
To monitor SEND signals, press the SEND switches one at a time, or press
SEND 1 and SEND 2 (or SEND 3 and SEND 4 ) simultaneously .
The SEND signal are passed to the MONI OUT 1 and MONI OUT 2
connectors as below.
When you press one SEND switch at a time
The selected SEND signal is routed to both the MONI OUT 1 and MONI
OUT 2 connectors.
When you press two SEND switches simultaneously
The selected odd numbered SEND signal (SEND 1 or SEND 3) is fed to
the MONI OUT 1 connector and the even numbered SEND signal (SEND
2 or SEND 4) is fed to MONI OUT 2 connector.
The SEND signals are monitored after the SEND MASTERS controls. So,
these signals reflect the output level.
The PFL switch is an enable switch for pre-fader listening.
When this switch has been depressed, the PFL signal is routed to MONI
OUT 1 and MONI OUT 2 connectors, whenever you press the PFL switch
on an input channel.
LINE
Select LINE OUT signals
1-2
EXT
Select EXT IN signals
1-2
RET
1-2
Select RETURN signals
RET
3-4
SEND
1
SEND
2
Select SEND signals
SEND
3
SEND
4
Select pre-fader monitoring
PFL
MONITOR SOURCE
Chapter 3 Connection and Operation
3-3