Sample System Configuration With A Custom Operation Panel And Environmental Equipment Connected - Sony SRP-X500P Operating Instructions Manual

Sample system configuration with a custom operation panel and
environmental equipment connected
In this configuration, the SRP-X500P can be controlled by a custom operation panel or an external system controller.
AN-820 UHF
Antenna or the
supplied antenna
Document
camera
VIDEO OUT
Table-top
VIDEO OUT
microphone, etc.
Programmable
remote
commander
• The SRP-X500P and the connected devices can be controlled by commands sent by an external system controller to the
SRP-X500P. (System controller software is required.)
• The configuration above uses two WRU-806 UHF Synthesizer Tuner Units or two URX-M1 Tuner Units included in
the UWP-X1/X2.
• When an electret condenser microphone is connected to the MIC INPUT 3 or 4 connector, set the +48V ON/OFF switch
for the applicable connector to ON.
• When controlling the environment equipment such as screen, curtains, and lighting equipment through the REMOTE
PARALLEL connector, interface boxes are required.
For details on the use of a custom operation panel and interface boxes, see "REMOTE PARALLEL connector" (page 24).
18
System Configurations and Speaker Connections
Transmitter
Wireless
microphone
LINE OUT
VCR , DVD player,
etc.
RGB OUT
PC
LINE OUT
PROJECTOR CONTROL RS-232C
Custom operation panel
Operation
terminal
External system controller
3 #
3 #
3 #
3
# 3 #
LINE OUT
LINE
IN
MD recorder
RGB OUT
PC
LINE
OUT
Projector
INPUT
AN-820 UHF
Antenna or the
supplied
antenna
Transmitter
Wireless
microphone
To power
source
I/F
BOX
Screen
I/F
BOX
Curtain
Rear
I/F
speaker (R)
BOX
Lighting
equipment
Front
speaker
(L)
Front
speaker
(R)
Rear
speaker (L)