Output And Monitor Signal Connectors - Sony MXP-310 Manual

2-4-3 Output and Monitor Signal Connectors

1 METER OUTPUT connector
2 y (ground) terminal
~
3
AC IN (inlet) connector
1 METER OUTPUT connectors (Din 8-pin)
Outputs the VU meter signal to connect the MXBK-
M301 VU meter unit (not supplied).
2 y (ground) terminal
Connect to the ground line.
3 ~AC IN (inlet) connector
Connect to an AC power source with the AC power
cord (supplied).
4 TB (talkback) connector (phono jack)
Outputs the talkback signal fed from the talkback
microphone, when the TB OUT switch on the
TALKBACK section is pressed. Connect an amplifier
to drive a talkback speaker.
METER OUTPUT
OUTPUT
RETURN SEND RETURN SEND RETURN
4 4 3 3
LINE LINE MONI
TB OUT PFL OUT OUT
2B 1B
LINE OUT
~ AC IN
2B 1B
2 1 2
MONI OUT
5 PFL (Pre-fader listening) connector (phono
jack)
Outputs the pre-fader signal directly from the pre-fader
listening bus. Connect an amplifier to drive a PFL
speaker.
6 RETURN connectors (phono jacks)
(channels 1 to 4)
Accept the signals returned from echo machines or
other effects devices.
7 SEND connectors (phono jacks)
(channels 1 to 4)
Output send master signals controlled by SEND
MASTERS 1 to 4. Connect effects devices or a cue
amplifier.
Chapter 2 Locations and Functions of Parts and Controls
4 TB connector
5 PFL connector
6 RETURN connectors 1 to 4
SEND RETURN SEND
2 2 1 1
7 SEND connectors 1 to 4
8 Unbalanced LINE OUT connectors
LINE MONI LINE 1A, 1B and 2A, 2B
OUT OUT OUT
2 2A 1 1A
9 Unbalanced MONI OUT
connectors 1 and 2
2A 1A
0 Balanced LINE OUT connectors
1A, 1B and 2A, 2B
!¡ EXT IN connectors 1 and 2
1
EXT IN
!™ Unbalanced MONI OUT
connectors 1 and 2
2-23