Connecting And Setting Up The Humidifier - Philips DreamStation Go Instructions For Use Manual

3.

Connecting and setting up the humidifier

Connecting to the therapy device
1. Remove the humidifier beauty panel from the
therapy device by pulling from either side of the
panel.
2. Place the therapy device and heated humidifier (with
an empty water tank) on a firm, flat surface.
3. Line up the front of the therapy device to the front of
the humidifier. Make sure the air outlet port on the
therapy device lines up with the air inlet port on the
humidifier.
4. Slide the therapy device and humidifier together
until they snap into place.
5. Make sure that the therapy device and the humidifier
are completely connected to each other.
6. Attach the tube to the heated humidifier. Line up
the connector at the top of the tube to the top of
the air outlet port on the humidifier after filling the
humidifier. Refer to the "Daily use" section. If you are
not using a 12mm tube, use the 15mm/22mm tube
adapter.
7. Press the tubing connector into place over the air
outlet port until the tube clicks into place in the slots
on the sides of the outlet port.
Pull here
Caution
Do not move the humidifier while the water tank has
water in it.
5