Cleaning And Maintenance; Cleaning The Condenser; Replacing The Light - Lincat C6R/75U User And Installation Instructions Manual

CLEANING AND MAINTENANCE

CLEANING
Disconnect the unit from the electricity supply. Use a mild detergent in
hot water and a soft cloth. Do not use abrasive creams or scourers.
Remove the rear doors, shelves and base panels. Shelves (including
supports) and base-panels may be washed in a dishwasher.
MAINTENANCE
Regular cleaning of the unit is recommended. No other regular maintenance is
required, but it may be necessary to clean the condenser or replace a light tube.

CLEANING THE CONDENSER

Disconnect the unit from the electricity supply.
For counter top models the condenser is located behind a grille on the operator
side of the appliance. Access the condenser by removing the screw holding the
grille in place using the Allen key provided. Use a vacuum cleaner to suck any
debris from the face of the condenser and replace the grille.
For drop in models the condenser is located at the front of the drop in module
and can be brushed down using a stiff bristled brush.

REPLACING THE LIGHT

Disconnect the unit from the electricity supply.
Remove doors. Unclip the end caps from the light unit. Remove the diffuser
from its clips. To remove the tube, carefully rotate it 90
until it is released. It is recommended that the starter (a round cylinder located
at one end of the tube) is also replaced at the same time. To remove the starter,
rotate it anticlockwise. Fitting the new tube is the reverse of the above
sequence.
IS517 ECN4508
o
Page 19
and slowly pull down