Smeg FS60XNG Instruction Manual page 10

3.3 Adjustment of the oven burner (only for gas oven models)
To adjust the oven burners follow the procedure
described below from inside the oven:
•
•
•
3.3.1
Loosen the fixing screws A on the
oven burner.
Push the burner B towards the right to
get to the nozzle.
Use a 13 socket wrench to change the
nozzle, fitting the one for the type of
gas to be used (see point "3.2 Table
of burner and nozzle characteristics").
3.3.2 Regulation of the primary air on the oven and grill burner
Loosen the register screws "A" on the air regulation
coupling.
Turn the register coupling "B" to the position
corresponding to the type of gas to be used
according to the table below.
Tighten the register screws and mount the seals.
Once the operation is completed reassemble the
burner correctly.
X =
12
Instructions for the installer
Open the oven door;
Remove the oven dish and shelf.
Lift up the oven floor and remove.
Replacement of the oven and grill burner nozzle
NG
1.0 KPa
10 mm
LPG ( )
PROPANE
2.75 KPa
15 mm