Installation; Packing List; Mounting The Unit - DeRoyal Aqua-Box 1200-00 Owner's Manual

F l u i d W a s t e E v a c u a t i o n & D i s p o s a l

INSTALLATION

The following procedures are important for correct mounting,
plumbing and electrical installation of the Aqua-Box. The
fluid disposal system is lightweight and can be mounted on
almost any wall with approximately drilled holes, anchors
and screws. For proper installation of the Aqua-Box, carefully
follow the instructions below.

PACKING LIST

(1) Aqua-Box Fluid Disposal System – Master Unit
(1) Automatic Control Box
(1500-00, 1300-00 & 1300-R Models only)
(1) 3/4" Electric Solenoid Valve
(1500-00 and 1300-00 Model only)
(1) RPZ (Reduced Pressure Zone) Valve
(except 1100-00 Model)
(1) 5 Foot Suction Hose with Thumb Valve
(1) 1/2" Valve and Hose for Disinfectant
(1) Tube of Thread Sealant
(1) Set of Screws and Wall Anchors
(5) Evacuation Tubes
MOUNTING THE UNIT: NON-RINSING MODELS
1. Models 1500, 1300 & 1200: Mount the Aqua-Box on the
wall no more than 5 feet off the floor (top of Aqua-Box) using
the #10 stainless steel screws and matching anchors provided
or by screwing directly into wall studs.
2. Models 1500 & 1300 only: Remove the cover of the
control box by unscrewing the four cover screws. Mount
the electrical control box on the wall at a position that is
comfortable, convenient and safe for staff with the #8 stainless
steel screws and matching anchors provided. The electrical
requirements are 110/120 AC Volts, 50/60-Hertz cycle, 3
Amps. Installation diagram follows. The Aqua-Box ships with
a standard heavy-duty 10 foot 110/120 Volt plug which may
be plugged directly into an electrical outlet. Optionally, it may
be hard wired. Replace the control box cover.
3. Model 1100: Remove the cover. There are four holes that
can be accessed through the box. Attach to wall approximately
five feet from floor to top of box using the #10 stainless steel
screws and matching anchors provided, or by screwing directly
into wall studs.
MOUNTING THE UNIT: RINSING MODELS
1. Mount the Aqua-Box Master Box on the wall such that
the top of the unit is 5 feet off the floor using the #10 stainless
steel screws and matching anchors provided or by screwing
directly into wall studs.
2. Remove the cover of the control box by unscrewing the
four cover screws. Mount the electrical control box on the
wall at a position that is comfortable, convenient and safe for
staff with the #8 stainless steel screws and matching anchors
provided. The black seal should give you a good guide for
placement. The electrical requirements are 110/120 Volt,
50/60-Hertz cycle, 3 amps. Installation diagram follows. The
Aqua-Box ships with a standard heavy-duty 10 foot 110/120
Volt plug which may be plugged directly into an electrical
outlet. Optionally, it may be hard wired. Replace the control
box cover.
9