Electrical Connections; Installation Diagrams: Electrical Connections - DeRoyal Aqua-Box 1200-00 Owner's Manual

F l u i d W a s t e E v a c u a t i o n & D i s p o s a l
ELECTRICAL CONNECTIONS: NON-RINSING UNITS
For Models 1500-00 and 1300-00 only, the following steps provide the instructions for the electrical connections.
1. Remove the cover from the control box
by unscrewing the four plastic cover screws.
2. Feed the three wires from the electric
solenoid valve into the control box. A rigid
or flexible conduit is recommended to house
the wires from the solenoid valve to the
control unit. A flexible conduit is included
with the Aqua-Box.
3. The electrical supply wires ship pre-
connected. Should they need to be
reconnected, the hot (white) wire should be
connected to post #1 and the neutral (black)
to post #2.
4. Connect one of the red wires from the
solenoid valve to post #8 and the other red
wire to post #2. The green (ground) wire
should be connected to post #3.
5. The control box cover should be replaced
by screwing clockwise the four plastic cover
screws.
6. Plug the control box into a standard
110/120 Volt electrical outlet. The electrical
outlet should be GFCI protected as per local
codes. The electrical connection may be hard
wired by cutting off the plug, if preferred.
13
(White)
(Black)
(Green)
(Red)
(Red)