Accessory Installation; Configurations - WEG CFW500 Series Installation, Configuration And Operations Manual

Serial Remote HMI

4 ACCESSORY INSTALLATION

The accessory is easily installed or replaced. For the
proper installation of the accessory, follow steps below:
Step 1: The CFW500-HMIR can be connected to any
CFW500 plug-in module. With the inverter de-energized,
remove the front cover of the Inverter
page 17).
Step 2: Connect the wires of the CFW500-CCHMIRxxM
cable to the RS485 connection on plug-in module
according to the
on page 17 shows an example with the CFW500-IOS
plug-in module. If you are using a different plug-in module,
refer to its installation, configuration and operation guide
to identify the terminals for the RS485 Serial Connection.
Step 3: Close the inverter front cover.
Step 4: Power up the inver ter and check if the
CFW500-HMIR as show the following mensage on
the display:
Step 5: Configure the parameter P0312 to HMIR option.
Thus, the Serial Remote HMI will show the same display
data as the inverter local HMI. Otherwise, repeat steps 1-5,
checking the CFW500-CCHMIRxxM cable connections.

5 CONFIGURATIONS

It is mounted externally to the inverters on the panel
„
door (Figure A2 on page
maximum cable length of 10 m. However, for cables
longer than 10 m, it is necessary an external power
supply of 24 Vdc to power up the Serial Remote HMI.
Protection rate: IP54 / Nema 12.
The CF W500-HMIR works with the CF W5 0 0 -
„
CCHMIRxxM cable only. The available lengths are
presented in
connection of this cable, check
6 | CFW500
Table 2 on page
18) or control desk with a
Table 1 on page
(Figure A1 on
7. The Figure A1
7. For the proper
Table 2 on page 7.