Remove The Power Module - Allen-Bradley PowerFlex 750 Series Installation Instructions Manual

PowerFlex 750-Series Service Cart and DC Precharge Module Lift

Remove the Power Module

Follow these sections to remove a power module from a control cabinet.
Prepare the Equipment for Service
This section prepares you to service LCL filter modules, power modules, or DC precharge module.
IMPORTANT The LCL filter or power module must be removed to remove a DC precharge module.
Follow these steps to prepare the equipment for removal.
1. Remove power and de-energize the cabinet.
See PowerFlex 755TM Power and Filter Module Storage Hardware Instructions, publication 750-IN106.
2. Open the door.
3. Remove all applicable safety guards.
a. Refer to this image for configurations that do not contain a DC precharge module.
The mounting screws for safety guards can remain in the cabinet. The safety guard slides past the head of a loosened screw.
The 800 mm (31.5 in.) cabinet configuration is shown and is typical of other sizes.
8
Example of safety guard flanges:
Rockwell Automation Publication 750-IN105D-EN-P - June 2018
M5.5
T25
4.8 N•m (23 lb•in)