Setup The Service Cart - Allen-Bradley PowerFlex 750 Series Installation Instructions Manual

PowerFlex 750-Series Service Cart and DC Precharge Module Lift
Required Tools
Required Tools for the Service Cart and DCPC Lift
Electric drill with a torque rating of 11.3 N•m (100 lb•in), min
15 mm ratcheting wrench
19 mm wrench
T30 bit
T25 bit
T45 bit
15 mm socket
25 mm socket
Aisle Clearance
The minimum aisle clearance that is required to maneuver and position the service cart is 914 mm (36 in.).
914 mm
(36 in.)

Setup the Service Cart

ATTENTION: Avoid personal injury, do not remove or disable the touch guards. Pinch points exist between the movable parts of the service cart. Review all
product labels and familiarize yourself with the potential pinch point hazards before you operate the service cart.
Remove all packaging from the service cart.
TIP If you plan to use the frames 8...10 conversion kit, see the PowerFlex 750-Series Service Cart Frames 8...10 Conversion Kit Installation Instructions,
publication 750-IN017
ATTENTION: The PowerFlex 750-Series service cart (20-750-MCART1) weighs approximately 60 kg (133 lb) and requires two persons to lift.
4
Recommended Tools
Masking tape
Bubble level
Pencil and paper
Pliers
Top View
152 mm
(6 in.)
for information to configure and install the optional frames 8...10 conversion kit.
Rockwell Automation Publication 750-IN105D-EN-P - June 2018