Use The Dcpc Module Lift (Optional) - Allen-Bradley PowerFlex 750 Series Installation Instructions Manual

Use the DCPC Module Lift (Optional)

DCPC Module Lift Components
The DCPC module lift is used only with a DC
precharge module. See Move the Power
Module and the DC Precharge Module on
page 16 if your system does not have a DC
precharge module.
Item Description
1 Locking Bar
2 Carriage
3 Locking Pin
4 Leveling Knobs
5 Auto-Lock
6 Assembly Pins
7 Rear Lock Plug
8 Carriage Slide
9 Front Lock Plug
The DCPC module lift weighs approximately
TIP
12 kg (25 lb).
Assemble the DCPC Module Lift
ATTENTION: Pinch point hazards exist with the DCPC module lift. To avoid personal injury, review all product labels and potential pinch point hazards before you
begin assembly.
Follow these steps to assemble the DCPC module lift.
1. Remove all packaging and inspect the DCPC module lift for any damage.
Read all labels and familiarize yourself with possible pinch points.
2. Position the carriage slide on a workbench with the front lock plug near you as shown for step 2.
3. With the leveling knobs towards you, place carriage wheels into the carriage slide.
4. Pull the carriage toward you and allow the auto-lock to engage into position.
5. Insert the locking pin.
6. Insert an assembly pin on each side of the carriage slide.
The DCPC module lift is ready for service.
2
4
5
9
4
3
Rockwell Automation Publication 750-IN105D-EN-P - June 2018
PowerFlex 750-Series Service Cart and DC Precharge Module Lift
1
As received
2
3
6
7
8
5
Assembled ISO-View
6
13