Advertisement
WIRING
To Connect External Wiring
To The Card Slots:
Siemens Industry, Inc.
Building Technologies Division
SLIDE DOWN CARDCAGE UNTIL
FLUSH ON TOP, LEFT, AND BOTTOM
CC-5 CARDCAGE
INSTALL TWO 10-32 SCREWS WHEN
ALIGNED WITH THREADED STUDS
Figure 4
Mounting The CC-5 On The Optional CAB-MP
At the top and bottom of the CC-5 and adjacent to each card slot are removable
terminal blocks. The wiring to the two terminal block connectors at the top of the CC-
5 is power limited. The wiring to the terminal block connector at the bottom of the
CC-5 is non-power limited.
(Figure 5)
1.
Insert the wire to be connected in the desired opening in the side of the
removable terminal block.
2.
Tighten the appropriate locking screw.
Figure 5
Removable Terminal Block On The CC-5
TOP
CAB-MP
4
P/N 315-099319-4
Advertisement
