Identification Plates - Mercedes-Benz SLC 300 2019 Operator's Manual

basic wiring. Be sure to observe the manufac-
turer's Supplement when installing.
Deviations with respect to frequency bands,
maximum transmission outputs or antenna
positions must be approved by Mercedes-
Benz.
The maximum transmission output (PEAK) at
the base of the antenna must not exceed the
following values:
Frequency band
Short wave
3 - 54 MHz
4 m waveband
74 - 88 MHz
2 m waveband
144 - 174 MHz
Trunked radio system/
Tetra
380 - 460 MHz
70 cm waveband
400 - 460 MHz
Mobile communications
(2G/3G/4G)
The following can be used in the vehicle with-
out restrictions:
RF transmitters with a maximum transmis-
R
sion output of up to 100 mW
RF transmitters with transmitter frequencies
R
in the 380 - 410 MHz waveband and a maxi-
mum transmission output of up to 2 W
(trunked radio/Tetra)
Mobile phones (2G/3G/4G)
R
There is no restriction for antenna positions on
the outside of the vehicle for the following fre-
quency bands:
Trunked radio system/Tetra
R
70 cm waveband
R
2G/3G/4G
R

Identification plates

Vehicle identification plate with
vehicle identification number (VIN)
Maximum
transmission
output
100 W
30 W
X
50 W
10 W
35 W
10 W
Example: vehicle identification plate (USA only)
:
;
Example: vehicle identification plate (Canada
only)
:
;
i
Identification plates
Open the driver's door.
You will see vehicle identification plate :.
VIN
Vehicle model
VIN
Paint code
The data shown on the vehicle identifica-
tion plate is used only as an example. This
297
Z