Download Print this page

ACTi R21CF-31 Installation Manual

Face recognition reader
Hide thumbs Also See for R21CF-31:

Advertisement

Quick Links

Face Recognition Reader
Installation Guide
R21CF-30, R21CF-31, R21CF-32, R21CF-33
2018/01/19

Advertisement

loading
Need help?

Need help?

Do you have a question about the R21CF-31 and is the answer not in the manual?

Questions and answers

Summary of Contents for ACTi R21CF-31

  • Page 1 Face Recognition Reader Installation Guide R21CF-30, R21CF-31, R21CF-32, R21CF-33 2018/01/19...
  • Page 2: Step 1: Prepare For Installation

    Step 1: Prepare for Installation A. Bundled accessories 1. Mounting bracket 2. Screw pack 3. Input/Outout cables B. Additional requirements 1. DC 12 V Power supply with at least 1.5A output 2. Ethernet cable Step 2: Know the Device The Device www.acti.com...
  • Page 3 12V Power OUT Black 12V Power OUT GND Blue Wiegand IN Data 0 Gray Wiegand IN Data 1 P3 (Communication) Green Wiegand OUT Data 0 White Wiegand OUT Data 1 Orange RS232 Tx Yellow RS232 Rx (Network) Standard Gigabit Ethernet www.acti.com...
  • Page 4: Step 3: Connect Other Devices

    Step 3: Connect Other Devices 1. Route the cables through the hole on the wall. 2. Connect the devices, such as the power adapter, to the cables with terminal block (refer to the earlier sections to check the proper wiring connections). www.acti.com...
  • Page 5: Step 4: Install The Device

    1.35 m 1.75 m 1.15 m 1.40 m 1.80 m 1.20 m 1.45 m 1.85 m 1.25 m 1.50 m 1.90 m 1.30 m 1.55 m 1.95 m Installation height (H) measured from the bottom of the device to ground www.acti.com...
  • Page 6 Apply screws to tighten above). the mounting bracket on the wall. Ensure the device is vertically installed and parallel to a vertical wall. Ensure power, network, communication, and I/O cables are available from the opening of the mounting bracket. www.acti.com...
  • Page 7 Slide the unit down to reach the bottom of the bracket. Power up the device to test if all the cables are connected correctly Finally, mount the two (2) bundled screws at the bottom of the device. www.acti.com...
  • Page 8 Copyright © 2018, ACTi Corporation All Rights Reserved 7F, No. 1, Alley 20, Lane 407, Sec. 2, Ti-Ding Blvd., Neihu District, Taipei, Taiwan 114, R.O.C. TEL : +886-2-2656-2588 FAX : +886-2-2656-2599 Email: sales@acti.com...

This manual is also suitable for:

R21cf-30R21cf-32R21cf-33