Handling The Modules; Instructions - SMC Networks SMC6724L2GLSC User Manual

I
NSTALLING THE

Handling the Modules

CAUTION: The modules can easily be damaged by electrostatic
discharge.
To prevent electrostatic damage, observe the following guidelines:
• Do not remove the module from its packaging until you are
ready to install it.
• Do not touch any of the module's pins, connectors or components.
• Hold the module only by its edges or front panel.
• Wear an anti-static wristband connected to a suitable earth
ground whenever handling the module.
• Store or transport this module only in appropriate anti-static
packaging.

Instructions

CAUTION: The switch must be powered off before installing or
replacing any module.
Power off the switch: Disconnect the AC power cord from
1.
the switch. If a redundant power unit (RPU) is present,
disconnect its DC cable connection to the switch.
Remove network cables: If you are replacing a module,
2.
remove the cable attached to the port on the module.
Loosen the screws on the installed module or slot
3.
faceplate: Using your fingers or a flathead screwdriver, turn
the screws securing the module (or faceplate on the slot) in a
counter-clockwise direction until they are free of the chassis.
Be sure not to completely remove the screws from the module
or faceplate.
4
M
ODULE