Belkin OmniView F1DS102P User Manual page 11

P73778-C-SOHO-man-9_02.qxd 9/18/02
INSTALLATION
Connect the Computer
5. Using a standard USB A to B cable (we recommend Belkin part number
F1D9101-XX), insert the end with the B-type connector to the KVM
Switch. Insert the other end of the cable with the A-type connector
to an available port on your USB computer or USB hub that is
attached to your computer. See Fig. 12.
6. Your computer should recognize the KVM Switch and will automatically
install the HID USB driver if not already installed on your computer.
5:17 PM Page 18
Fig. 12
18
INSTALLATION
Audio and Microphone Connections
Recommended Belkin OmniView KVM Cables for SOHO Series with Audio
are included with Belkin part number F1D9101-XX.
Note: Speakers and microphones are not required for use of your
KVM Switch.
Connect the Audio
7. Using the audio cable attached to your speakers, connect the male
3.5mm plug to the lime audio jack in the "Console" section of the
KVM Switch. See Fig. 13.
Fig. 13
8. Using the mic cable attached to your microphone, connect the male
3.5mm plug to the pink mic jack in the "Console" section of the KVM
Switch. See Fig. 13.
19