Page 1
Products: Synopsis: This guide will assist you in updating the firmware of your Belkin OmniView SOHO KVM Switch. Please be advised that firmware updates tend to be to resolve specific issues and if there is any doubt if the firmware will resolve your issue you F1DS102P should check with Technical Support.
Page 2
The KVM Unit itself now needs to be set to Flash Update mode. To do this simply locate the ‘Flash’ button on the interior of the KVM unit and depress it. TSG-UK-2-005 TSG-UK-1-001 www.belkin.com www.belkin.com Page 2 of 4 Page 1 of 1...
Page 3
To resolve this click ‘OK’ and ‘OK’ again. Unplug Power from the KVM, then unplug the Flash Update Cable. Wait 10 seconds. Now plug the Flash Update Cable in first, followed by the Power Cable (or KVM Cable Kit). Repeat Step 4. TSG-UK-2-005 TSG-UK-1-001 www.belkin.com www.belkin.com Page 3 of 4 Page 1 of 1...
Page 4
Should the unit emit a persistent beep after the Flash Update process then it is indicating that the Firmware has been in some way corrupted. The unit should be re- flashed using an original Firmware with KVM set again to ‘Flash’ mode. TSG-UK-2-005 TSG-UK-1-001 www.belkin.com www.belkin.com Page 4 of 4 Page 1 of 1...