Table of Contents
Advertisement
Pre-installation
Environmental Conditions
Mounting Instructions
Electrical Connections
Installation
1. Inspect the device for shipping damage.
2. See
Before You Begin on page
3. Record the i-Sense monitor serial number.
4. Register the monitor at www.igrid.com.
5. Configure the monitor hardware for the service voltage.
6. Configure the communication software using the Ethernet port (this can
be done after installation and power-up).
WARNING: Do not apply power to the monitor until the wiring is completed
and right-side cover is replaced. Installation must be performed by an
electrician, in accordance with all local, and national codes.
The monitor is rated for installation in the following environment:
• Indoor use only, no conductive pollution.
• Altitude up to 2000 m (6500 ft).
• Temperature range 0...40 °C (32...104 °F).
• Maximum relative humidity 95%, noncondensing.
• Provide 10 in. (250 mm) clearance around the monitor for cooling and
access.
• Remove the left and right covers (four Phillips screws, two at the top and
two at the bottom).
• Mount the monitor to a vertical surface using the four mounting holes.
Two of the four mounting screws should penetrate into studs at least 1 in.
(25 mm), screws at least 1.5 in. (38 mm) long recommended.
1. Install branch protection: upstream fuse or circuit breaker protection rated
20 A or less is required. Protection rated less than 5 A is not
recommended.
2. Conduit entry available from the top or bottom.
3. Connect the Ground (Earth) wire to the #10-32 stud near the bottom
knock-out.
4. Connect mains line to the INPUT_1 terminal block, according to the
proper wiring diagram from
INPUT_2 terminal block is present, wire the second 3-phase set using the
same wiring diagram.
Rockwell Automation Publication 1608S-UM001C-EN-P - November 2018
7.
Table
5. For the 6-channel version only: if the
3
Chapter
15
Advertisement
Table of Contents
