Table of Contents
Advertisement
Rear Panel Description
Item
Description
Power
Connect the included power adapter to this port.
Reset
Use this button to reset the power or restore the default factory settings.
LAN 1-4
Four 10/100 Auto-sensing switch ports (RJ-45). Connect devices on your local
area network to these ports (such as a PC, hub, or switch).
USB
Connect a USB Cable from your PC to this port.
CATV
Connect your cable line to this port.
Rebooting and Restoring the EZ Connect™ Wireless Cable Modem Gateway
The Reset button is located on the rear panel of the Gateway. Use a paper clip or a pencil tip
to push the Reset button.
Reboot
If the Gateway is having problems connecting to the Internet, simply hold down the reset
button for less than 2 seconds then release.
Restore Factory Defaults
If rebooting the Gateway does not resolve your issue, then you can follow these steps:
1. Leave power plugged into the Gateway.
2. Locate the reset button on the back panel, press and hold button for at least 5 seconds.
3. Release reset button.
Power
Reset
Button
LAN
Connector
Ports
USB
CATV
Advertisement
Table of Contents
