Safety Precautions - AudioCodes Mediant 800 Quick Setup Manual

Safety Precautions

This device is an indoor unit and therefore, must not be installed outdoors. Ethernet cabling must be

routed only indoors and must not exit the building.
The device must be installed and serviced only by qualified service personnel.

Do not open or dismantle the device.

Do not expose the device to water or moisture.

Make sure the device is installed in a well-ventilated location to avoid over heating of internal

components and subsequent damage.
Do not place any object on top of the device and make sure that sufficient clearance from the top and

sides are maintained to ensure proper airflow to avoid over heating of internal components.
Operate the device in an ambient temperature (Tma) that does not exceed 40°C (104°F).

The device must be installed only in restricted access locations.

For AC power, use only the supplied AC power cord for connection to the power source.

The device must be connected to an electrical socket-outlet providing a protective earthing connection.

Operate the device only from the type of power source indicated on the chassis.

For DC power, use only the AC/DC power adaptor that is supplied by AudioCodes.

Installation of the device must be in accordance with national wiring codes and conform to local

regulations.
The device must be installed only in telecommunication sites in compliance with ETS 300-253

requirements "Earthing and Bonding of Telecommunication Equipment in Telecommunication
Centers".
Prior to installation, earth loop impedance test must be performed by a certified electrician to ensure

grounding suitability at the power outlet intended to feed the device. It is essential that impedance is
kept below 0.5 ohms.
9 | P a g e