Chapter4. How To Create A Cmt-G03 Project; Create A New Project - weintek CMT G03 Series User Manual

Chapter4. How to create a cMT-G03 project
This chapter explains how to create a project when cMT-G03 is used as an OPC UA Server, and how
to set the addresses used to communicate with OPC UA Clients. The basic steps are:
1. Add a driver into Device List in EasyBuilder Pro.
2. Enable OPC UA Server and designate communication address.
3. Download the project to HMI.
The following explains how to set up OPC UA Server in the project.

4.1. Create a new project

Step 1. Launch EasyBuilder Pro and select a cMT-G03.
Step 2. Configure In(HMI)/Out(PLC) communication parameters.
V1.0.0
cMT-G03 User Manual
14