Table of Contents
Advertisement
Heatable seat
The seat is not warm
enough.
The seat temperature is
too high.
Problem
Rearwash/Ladywash
Switching between the
Rearwash and
Ladywash takes too
long.
The water spray
intensity is too weak.
The water spray
29
The batteries are flat.
The battery connections
are reversed.
The contact between
the battery and the
battery spring is poor.
The remote control is
defective.
The Remote Control is
not matched properly.
The seat temperature
has been set to "Off" or
"Low".
The product is in the
8-hour-seat-off
"Timed Energy Saving
mode".
The seat temperature
has been set to "High".
Potential cause
When switching
between Rearwash and
Ladywash, the spray
wand moves back and
then forward again after
self-cleaning is
complete.
The water spray
intensity has been set
to "Low".
The water supply hose
has buckled.
The water filter is
> Change the batteries.
> Insert the batteries
the correct way round.
> Make sure the battery
spring contact is good.
> Contact your installer.
> Match the Remote
Control again.
> Adjust the seat
temperature to
"Medium" or "High".
This is normal.
> To heat the seat
continuously, please
switch off the "timed
energy saving mode".
> Adjust the seat
temperature to
"Medium" or "Low".
Solution
This is normal.
> Adjust the water spray
intensity to "Medium" or
"High".
> Contact your installer.
> Clean the water
8.7
7.5
7.7
7.5
Ch.
7.3
8.6
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
