Table of Contents
Advertisement
2.4 To disassemble/assemble the
control unit and/or wireless unit*
Tools: Torx 9 screwdriver.
1. Control unit:
- Disconnect the cable (A) to the wireless unit.
- Remove the 3 torx TX9 screws (B) screws.
- Exchange the control unit.
- Disconnect the 3 wires (C).
- Install and tighten the 3 torx TX9 (B) screws,
torque max 0.8 Nm.
- Connect the cable (A) to the wireless unit.
- Check the circuit diagram and install the 3 wires (C)
accordingly on the control unit.
A
B
B
C
2. Wireless unit*:
- Disconnect the cable (A) to the wireless unit.
- Slide the wireless unit out (B).
- Exchange the wireless unit.
- Slide the wireless unit back (B).
- Connect the cable (A) to the wireless unit.
3. Reconfigure the pairing of the product and the handle,
see section "2.5 To pair the product and the handle*".
A
* PW 235R version only
B
B
2.5 To pair the product and the
handle*
* PW 235R version only
Pairing of the wireless devices is needed if:
•
The handle has been exchanged.
•
The wireless unit of the handle has been exchanged.
•
The control unit in the product has been exchanged.
•
The wireless unit in the product has been
exchanged.
•
If the user has not paired the product and the handle.
Pairing of the product and the handle:
1. Make sure that the product is not switched on.
2. Remove the battery and attach the battery again.
3. The orange indicator on the handle is now flashing for
approx. 2 minutes. This indicates that the handle is in
pairing mode.
4. Switch on the product within the 2 minute of pairing
mode. When the orange indicator stops blinking, the
handle and the product has been paired and can now be
operated.
2.6 To exchange the battery in the
handle*
* PW 235R version only
1. Remove the screw (Philips) and the battery cover.
2. Remove the old battery.
3. Make sure that the new battery (type CR 2032) is
placed with the correct polarity in the battery holder.
4. Install the battery cover and the screw.
Repair instructions
English – 7
Hide quick links:
Advertisement
Table of Contents
