US Robotics USR5420 User Manual page 4

Contents:
About the 802.11g
Wireless USB Adapter
Network Configuration
and Planning
Adapter Installation and
Configuration for
Windows
98SE/2000/Me/XP
Navigating the Wireless
Configuration Utility
Troubleshooting
Glossary
Product Specifications
for 802.11g Wireless
USB Adapter
U.S. Robotics
Corporation Limited
Warranty
Regulatory Information
802.11g Wireless USB Adapter User Guide
Adapter Installation and Configuration for
Windows 98SE/2000/Me/XP
SYSTEM REQUIREMENTS
In order to install and use the 802.11g Wireless USB Adapter, your computer must
meet the following requirements:
An available USB port
500 Kb free disk space for utility and driver installation
802.11g Wireless USB Adapter Installation
Prepare for installation
ATTENTION: You must install your software and drivers before you physically
connect the 802.11g Wireless USB Adapter.
Note: For the most updated information, visit:
Turn on your desktop or laptop computer. Type your password if you are prompted
to do so.
Attention Windows XP Users: Before you install the 802.11g Wireless USB
Adapter, you must have Service Pack 1 installed on your computer. If you do not
have Service Pack 1 installed, the 802.11g Wireless USB Adapter software will not
be properly installed and the adapter will not function correctly.
Note: Be sure to find out what letter your CD-ROM drive uses before you begin
installing your new product. You will need to know this to properly install your
software.
Note: During the Installation procedure, you may be prompted for your Windows
Operating system CD-ROM. Make sure you have it available in case you need it.
Step One: Install your software and drivers
Insert your U.S. Robotics Installation CD-ROM into your CD-ROM drive.
Note: If your CD-ROM does not automatically launch, click Windows Start, Run,
and type D:\setup (if your CD-ROM drive uses a different letter, type that letter in
place of "D") and click OK.
The Installation CD Graphic User Interface (GUI) will appear on your screen. If
prompted, select your preferred language. Read the license agreement and click
Yes.
Click Software.
http://www.usr.com/support