US Robotics USR1120 Installation Manual

11 mbps wireless usb adapter

Hide thumbs Also See for USR1120:

Download this manual See also: Reference Manual

11 Mbps Wireless USB Adapter

Note:

For the most updated information, visit: http://www.usr.com/

support. You can also refer to the Companion Reference Guide and to

the User Guide on the U.S. Robotics Installation CD-ROM for more

information.

Prepare for installation

Turn on your desktop or laptop computer. Type your password if you are

prompted to do so.

Make sure you have an available USB port on your computer.

Note:

Your product number is 1120. It is very important that you have

your serial number written down before you install the 11 Mbps

Wireless USB Adapter. If you ever need to call our Technical Support

department, you will need this number to receive assistance.

Note:

Be sure to find out what letter your CD-ROM drive uses before

you begin installing your new product. You will need to know this to

properly install your software.

Serial Number

R24.0270.00

Page 1: Prepare For Installation
11 Mbps Wireless USB Adapter Note: For the most updated information, visit: http://www.usr.com/ support. You can also refer to the Companion Reference Guide and to the User Guide on the U.S. Robotics Installation CD-ROM for more information. Prepare for installation Turn on your desktop or laptop computer.
Page 2 Next. You will be prompted for an SSID. If you do not have an existing wireless network, leave the default setting of ANY and click Next. If you have an existing wireless network, enter the SSID and click Next. Continue to follow the on-screen instructions to finish the installation procedure.
Page 3 ROM. Insert your Windows Operating System CD-ROM into the CD-ROM drive. When Windows is finished copying files, remove the Windows Operating System CD-ROM. * A Digital Signature Not Found window may appear. Click Yes. Windows Me and 2000 will verify that your network device is properly installed.
Page 4 User Guide on the U.S. Robotics Installation CD for this information. The 11 Mbps Wireless USB Adapters are set to Infrastructure/Auto Detect by default. 802.11b Ad Hoc mode is used for peer-to-peer network configurations. Infrastructure mode is used to add a Wireless Access Point to the wireless network configuration.