Dimplex Ignite 50" Owner's Manual page 8

Fireplace Installation
hole drilled for electrical wire
routing.
!
NOTE: It is recommended that
the bottom of the unit be mounted
between 30 in. (76.2 cm) and 40
in. (102 cm) from the ground to
maintain an optimized viewing
angle of the flame.
WARNING: Do not attempt to
wire your own new circuits. To reduce
the risk of fire, electric shock or injury
to persons, always use a licensed
electrician.
WARNING: Ensure that the
circuit on which the fireplace is to
be installed has the power cut off
at the service panel until installation
is complete.
2. The unit is provided with an
installed ¾ in. (2.0 cm) trim.
Depending on the installation,
this trim can be removed by
Figure 2
8
removing the securing screws
and the 4 trim pieces.
3. Lift fireplace, from the bottom
and the handles located on the
back, and insert into opening to
the desired depth.
4. Using a bubble level (supplied)
ensure that the fireplace is level
within the framing. Adjust as
required.
5. Drive four supplied mounting
screws through the four mounting
holes located on the inside
surface of the fireplace chassis,
into wall studs (Figure 2).
Mounting Holes
Flame
Panel