Opening And Closing The Camera; Inserting The Batteries/Connecting Power Supply - Kompernass WK 5 A1 Operating Instructions Manual

Opening and closing the camera

GB
The control buttons, connections and the battery compartment are
IE
inside the camera.
♦ Undo both of the side locking clamps
♦ To close the camera, hook the metal bars of the locking clamps
into the brackets and then press the plastic latch downwards.
There is a locking eyelet
which you can securely close the camera with the help of a padlock.

Inserting the batteries/connecting power supply

♦ To insert batteries
♦ Now press the latch on the upper side of the battery compartment
down a little way and lift the battery compartment cover off.
♦ Insert 4 or 8 x 1.5 V AA/mignon batteries into the battery com-
partment
NOTICE
► When using 4 batteries, these can either all be inserted in the
upper part or all in the lower part of the battery compartment.
Other combinations are not possible.
♦ Close and secure the battery compartment. Ensure that the bat-
tery compartment cover clicks firmly in place.
♦ If you are operating the device on a mains adaptor (not supplied),
open the rubber seal on the bottom of the camera and insert the
plug of the AC adapter cable into the DC socket
adapter must supply a direct-current voltage of 6 V with at least
1.5 A. Use a barrel jack whose interior polarity is connected to
the plus pole (
14
between the two locking clamps with
5
in the device, open the camera.
35
. Ensure that the polarity is correct.
11
).
to open the camera.
12
. The mains
20
WK 5 A1