Table of Contents
Advertisement
Warnings
Please carefully read all warnings and ONLY install the meter when you
are sure that you've covered all aspects.
*
Connect the meter according to current IEE regulations and separate all
wiring according to IEC1010.
*
Power supplies to this equipment must have anti-surge (T) fuses at 125mA for 230V
supply, 250mA for 110V supply or 1A for DC supplies in the range 11-30VDC.
*
Check that the model number and supply voltage suit your application before
you install the meter.
*
Don't touch any circuitry after you have connected the meter, because there may be lethal
voltages on the circuit board.
*
We designed this meter for Pollution-Degree 2 environments only. This means you must
install it in a clean, dry environment.
*
Only adjust on-board switches or connections with the power turned off.
*
Make sure all screw terminals are tight before you switch the meter on.
*
Only clean the meter with a soft damp cloth. Only lightly dampen with water. Do not use any
other solvents.
!
2
Advertisement
Table of Contents
Need help?
Do you have a question about the EasyReader ER4S and is the answer not in the manual?