Monogram ZET1DJSS Owner's Manual page 24

Before you
call for service
24
Problem Possible Cause
Why is my Your range has been designed to
range making a maintain a tighter control over your oven's
"clicking" noise temperature. You may hear your oven's
when using my heating elements "click" on and off more
oven? frequently than in older ovens to achieve
better results during baking, broiling,
convection, and self-clean cycles.
Clock and timer A fuse in your home may be blown or the
do not work circuit breaker tripped.
Oven light does Light bulb is broken or defective.
not work
Pad operating light is broken.
Oven will not The temperature is too high to set a
self-clean self-clean operation.
Oven controls improperly set.
Excessive Excessive soil or grease.
smoking during
clean cycle
Excessive Food too close to burner element.
smoking during
broiling
Oven door will Oven too hot.
not open after a
clean cycle
Oven not clean Oven controls improperly set.
after a clean
Oven was heavily soiled.
cycle
"LOCKED" The self-clean cycle has been selected
flashes in the but the door is not closed.
display to cook
"LOCKED" will flash while the oven door
is locking to start self-clean.
"LOCKED" is on The oven door is locked because the
when you want temperature inside the oven has not
to cook dropped below the locking temperature.
"LOCKED" The controls have been locked.
appears in the
oven display
"F— and a You have a function error code.
number or
letter" flash in
the display
If the function code repeats.
Troubleshooting Tips
Wall Oven
What To Do
This is normal.
Replace the fuse or reset the circuit
breaker.
Tighten or replace bulb.
Call for service.
Allow the oven to cool and reset the
controls.
See the Cleaning the Oven section.
Press the Cancel/Off pad. Open the
windows to rid the room of smoke. Wait
until the LOCKED light goes off. Wipe up
the excess soil and reset the clean cycle.
Lower the rack position of the food.
Allow the oven to cool below locking
temperature.
See the Cleaning the Oven section.
Clean up heavy spillovers before starting
the clean cycle. Heavily soiled ovens may
need to self-clean again or for a longer
period of time.
Close the oven door. Wait for oven door
to finish locking.
This is normal.
Press the Cancel/Off pad. Allow the oven
to cool.
See the Control Lock section to unlock
Press the Cancel/Off pad. Allow the oven
to cool for one hour. Put the oven back
into operation.
Disconnect all power to the oven for at
least 30 seconds and then reconnect
power. If the function error code repeats,
call for service.
49-80784-1