Probe; Oven Light - Monogram ZET1DJSS Owner's Manual

Probe

Oven Light

49-80784-1
The temperature probe may be cleaned with
soap and water or a soap-filled scouring pad.
Cool the temperature probe before cleaning.
Scour stubborn spots with a soap-filled
scouring pad, rinse and dry.
To order additional temperature probes read
the Assistance and Accessories sections at
the beginning of this manual.
Do not immerse the temperature probe in
water.
Do not store the temperature probe in the
oven.
Do not leave the temperature probe inside
the oven during a self clean cycle.
SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the
WARNING
electrical power to the oven at the main fuse or circuit breaker panel. Failure to
do so may result in electric shock or burn.
BURN HAZARD: The glass cover and bulb should be removed when cool.
CAUTION
Touching hot glass with bare hands or a damp cloth can cause burns.
To remove:
1. Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear
the grooves of the socket. Wearing latex
gloves may offer a better grip.
2. Using gloves or a dry cloth, remove the
bulb by pulling it straight out.
To replace:
1. Use a new 120/130-volt halogen bulb, not
to exceed 50 watts. Replace the bulb with
the same type of bulb that was removed.
Be sure the replacement bulb is rated 120
volts or 130 volts (NOT 12 volts).
2. Using gloves or a dry cloth, remove the
bulb from its packaging. Do not touch the
bulb with bare fingers. Oil from skin will
damage the bulb and shorten its life.
3. Push the bulb straight into the receptacle
all the way.
4. Place the tabs of the glass cover into the
grooves of the socket. Turn the glass
cover clockwise 1/4 turn.
For improved lighting inside the oven,
clean the glass cover frequently using a
wet cloth. This should be done when the
oven is completely cool.
5. Reconnect electrical power to the oven.
Care and Cleaning
Wall Oven
Receptacle
Glass cover
Receptacle
Socket
G9 Bulb
Tab
Use gloves
or cloth
21