Copying Files Using IBASIC Commands
Copying Files Using IBASIC Commands
Files can be copied from one mass storage device to another using the IBASIC
COPY command. For example, to copy a file from a memory card to the left drive
of an external dual-disk drive with a mass storage volume specifier of ":,702,0",
execute the following IBASIC command from the TESTS (IBASIC Controller)
command line:
COPY "FM_TEST:INTERNAL,4" TO "FM_TEST:,704,0"
"Stored" or "saved" files on one memory card can be copied to another memory
card as follows:
•
Insert the memory card containing the file to be copied.
1
•
LOAD or GET
the desired file from the memory card into the Test Set.
•
Remove the original memory card.
•
Insert the destination memory card in the Test Set.
1
•
STORE or SAVE
the file to the destination memory card.
1.
See
"Storing Code Files" on page 224
STORE, and SAVE commands.
S:\HP8924C\USRGUIDE\BOOK\chapters\memcard.fb
Chapter 5, Memory Cards/Mass Storage
for information about the LOAD, GET,
233